Market Education

Definition Of P E

Question: 

What does “P.E.” stand for in building construction?

Impact Sound Transmission Through Floor Assembly

Question: 

A condominium project I am involved with is experiencing a sound transfer problem through the floor/ceiling assembly between the first and second floor. You can hear every footstep, from an adult to a child. The floor assembly consists of a carpet and pad, 3/4 in. OSB sub-flooring, 15 in. deep wood trusses at 16 in. on center, 9 in. fiberglass batt insulation and a 5/8 in. gypsum board ceiling. The trusses span 20 ft. with air/heat ducts between the trusses. Will an additional layer of 5/8 in. gypsum board attached to 7/8 in.

Hand Built Trusses

Question: 

I am building a new shop that is 30 ft. x 32 ft. I need to free-span the 30 ft. dimension. Where can I get a load chart that recommends lumber size and strategic locations of the angle braces to support the free span? I am going to field erect the trusses and stick build them on the building.

Wood Framing

Question: 

I am conducting an investigation on the costs associated with building a 15,000 sq. ft. addition to an existing school building. I need to determine if wood trusses, steel bar joists or light gauge steel trusses would be the most economical material for the building system. The truss spans range from 42 ft. to 56 ft.

Floor Trusses With Masonry Bearing Walls

Question: 

We would like to know if there is a problem with using wood floor trusses with masonry bearing walls without a ledger. Our local supplier has told me that encasing the wood truss in the masonry wall could be detrimental to the truss due to moisture. What, if any, suggestions do you have for this condition? If a bottom chord bearing is used, do the trusses need fire cuts? The two-story building contains masonry bearing walls with wood trusses on the second floor and wood trusses at the roof.

Floor Vibration

Question: 

We have designed a custom home that needs a good solid floor, with low vibration perceptibility. The system we have specified consists of 2 in. of gypcrete over 1 and 1/8 in. thick plywood or OSB. The floor trusses are 20 in. deep at 16 in. O.C., spanning 31 ft. 6 in. The preliminary truss design shows a double top and bottom chord with a total load deflection of 1.30 in. (l/290) and a live load deflection of 0.65 in. (l/581). The basement ceiling will be 1/2 in. gypboard nailed to the bottom of the trusses.

Truss Blow Down

Question: 

If trusses blew down from insufficient temporary bracing and the contractor put them back up without the knowledge of the truss manufacturer and gave the truss manufacturer a letter stating that the trusses were okay, is that sufficient? Do you know of any truss manufacturer who would accept this?

Energy Heels

Question: 

What is the definition of an energy heel?

Deck Ledger Boards

Question: 

Is it possible to attach deck ledger boards to the ends of floor trusses? If not, are there any modifications that would make this possible?

In Floor Radiant Heat

Question: 

Do you have any information on the use of in-floor radiant heat with 4x2 open-web floor trusses? Are there any adverse effects to the lumber as a result of moisture build up?