Software

Designing Beyond the Defaults

Better understanding of project nuances can lead to an improved design

A Straightforward Approach to a Round Design

Challenging or unusual projects typically stretch a component manufacturer’s (CM’s) operational capabilities in some fashion.

I am a structural engineer designing pool cage structures that are typically attached to the house at the fascia board. Sometimes, the structure is attached where trusses are behind the fascia board and other times there is a framed gable end overhang. Do you know of any information concerning this additional load on the trusses or overhang under design wind loads? Is there a limiting distance on the amount of overhang? I know trusses are designed for certain uplift and the pool cage will add to this uplift at design load, but what about the gable end overhangs?

Turb O Webs

Question:

We have been using Turb-O-Webs for about four months. We are very happy with their performance, although there have been a few ripples along the way. The main thing that concerns me at present is the need for performance documentation and testing data. Do you have anything that will help, or know of people or organizations that could offer assistance?

Structural Composite Lumber In Trusses

Question:

The lumber used in most metal plate connected wood trusses is either visually- or mechanically-graded solid sawn dimensional lumber. However, the Truss Plate Institute's ANSI/TPI 1 allows the use of structural composite lumber (SCL) products such as laminated veneer lumber (LVL), laminated strand lumber (LSL) and parallel strand lumber (PSL). These engineered wood products can conceivably compete with sawn lumber and complement it in truss designs.

Designing Trusses

Question:

I'm looking for a book that will provide formulas and design criteria for trusses. Can you give me any suggestions of where to find a book or fairly inexpensive software?